Windsor Radius 28 DeLuxe Instructions d'exploitation télécharger pdf (Page 8)

8 English

Figure 6, see cover page

Î Slightly press the pushing handle down-

ward so that the appliance lifts up slight-

ly towards the front.

Î Move the appliance with the raised up-

per part over the dirt.

Î Now lower the appliance again.

The battery display shows the charging sta-

tus of the battery during operations:

몇 Warning

Risk of injury on account of rotating roller

brush.

Before removing the waste container

please turn the programme selection to

"OFF" and wait until the roller brush comes

to a halt.

Note

Dust progress. As far as possible, shake off

the filter and empty the waste container in

open places.

Î Turn the program selection switch to

"OFF".

Î Only DeLuxe model: Pull the handle of

the filter shake-off many times and rele-

aes it.

Î Only DeLuxe model: Tilt the dust suc-

tion upward.

Î Pull the waste container upward at the

handle and remove it from the appli-

ance.

Figure 7, see cover page

Î Dispose off the waste according to local

regulations.

Î Turn the program selection switch to

"OFF".

Î Lift the appliance at the carrying han-

dles when you want to transport it.

Î Secure the wheels of the machine with

wheel chocks.

Î Secure the machine with tensioning

straps or cables.

If the sweeper is going to be out of service

for a longer time period, observe the follow-

ing points:

Î Park the sweeper on an even surface.

Î Lock the sweeper to ensure that it does

not roll off.

Î Clean the inside and outside of the

sweeper.

몇 Warning

Danger of damage to the machine because

of water penetrating into the machine! The

machine should not be sprayed using a

high pressure water jet.

Î Park the machine in a safe and dry

place.

Î Disconnect battery.

Î Charge battery and recharge it approx.

every 2 months.

 Danger

Risk of injury. Before performing any tasks

at the machine, first turn the programme se-

lection switch to "OFF“and clamp the cable

at the minus pole of the battery.

 Danger

Risk of injury! Wear dust mask and protec-

tive goggles.

Î Clean machine with a cloth.

Î Blow through machine with compressed

air.

Î Clean the machine with a damp cloth

which has been soaked in mild deter-

gent.

Note

Do not use aggressive cleaning agents.

Daily maintenance:

Î Check the sweeping roller and the side

brush for wear and wrapped belts.

Î Check function of all operator control el-

ements.

Weekly maintenance:

Î Clean both the foam filters under flow-

ing water.

Î Only DeLuxe model: Check flat-fold fil-

ter.

Î Check moving parts for freedom of

movement.

Î Check the sealing strips in the sweeping

area for wear.

Half-yearly maintenance:

Î Check tension, wear and tear and func-

tioning of the drive belts.

Maintenance following wear:

Î Replace sealing strips.

Î Replace roller brush.

Î Replace side brush.

For description, see section on Mainte-

nance work.

Note

Where maintenance is carried out by the

customer, all service and maintenance

work must be undertaken by a qualified

specialist. If required, a specialised Archer

dealer may be contacted at any time.

Preparation:

Î Park the sweeper on an even surface.

Î Turn the program selection switch to

"OFF".

Î Loosen 3 fastening screws.

Î Replace side brushes and tighten the

screws.

It is necesary to replace them if the sweep

results are visibly poorer due to wear and

tear of the brushes and it is not possible to

readjust them using "Lever contact pres-

sure of sweep roller".

Î Remove the waste container.

Figure 8, see cover page

Î Pull the lever for contact pressure of

sweep roller fully backwards.

Î Loosen 3 screws each on both the sides

of the sweep roller.

Î Separate the roller halves and remove

them.

Î Place new roller halfs on the sweep roll-

er shaft. Ensure that the pins are sitting

correctly.

Î Fix in the screws and tighten them.

Î Loosen the screws as shown in the re-

spective diagram.

Î Remove the sealing strip and replace it

with a new sealing strip.

Î Fix in the screws and tighten them.

Front sealing strip (at the waste contain-

er)

Figure 9, see cover page

Rear sealing strip

Figure 10, see cover page

Side sealing strips

Figure 11, see cover page

Î Pull the handle of the filter shake-off

many times and releaes it.

Î Tilt the dust suction upward.

Figure 12, see cover page

Î Lift out the flat-fold filter and insert a

new flat-fold filter.

Î Remove both the foam filters.

Î Clean the foam filters under flowing wa-

ter and let them dry.

Î Push in the foam filters into the casing.

Ensure that the foam filters are gap-free

on all sides.

Collect dirt

Battery display

full glows green

30% capacity remaining glows yellow

10% capacity remaining blinks red

Protection against total

discharge; the appliance

is switched off

glows red

Emptying waste container

Transport

Shutdown

Maintenance and care

Cleaning the inside of the machine

External cleaning of the appliance

Maintenance intervals

Maintenance Works

Replacing side brush

Replacing roller brush

Replace the sealing strips

Replace flat fold filter (only DeLuxe mod-

el).

Cleaning the flat-fold filter

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 27 28

Commentaires sur ces manuels

Pas de commentaire

Windsor Radius 28 DeLuxe Instructions d'exploitation Page 8

Commentaires sur ces manuels

Produits connexes et manuels pour Aspirateurs Windsor Radius 28 DeLuxe