Windsor CDT7IHB Instructions d'exploitation télécharger pdf (Page 15)

CLEANING PROCEDURE

CDT7IHB 86036840 03/12/07

3-8

1ft.

(30cm)

Release intermittent setting or turn

off continuous setting on

brush/spray switch approximately 1

foot before ending cleaning pass.

Push down on handle to raise

vacuum shoe and brush before

moving to the next cleaning pass.

Overlap brush contact area a

minimum of 1 inch on the right

(close cleaning) side of machine.

Overlap a minimum of 2 inches on

the left (drive belt) side of machine.

During operation, observe the following:

The Cadet is equipped with clear

internal covers to facilitate operator

viewing of dirty solution and vacuum air

flow.

During operation, observe the vacuum

intake cover. Large amounts of water or

foam entering the vacuum system can

damage the vacuum motor. If you

notice either condition, shut down the

machine immediately. Empty recovery

tank and/or add defoamer to recovery

tank.

STEP

Start at wall closest to power outlet.

Pull straight back without pushing

down on handle.

STEP

SOLUTION

INTAKE COVER

VACUUM

INTAKE COVER

1in.

(25mm)

OFF

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 40 41

Pas de commentaire

Windsor CDT7IHB Instructions d'exploitation Page 15