Windsor CBE20 Instructions d'exploitation télécharger pdf (Page 28)

Maintenance

Use Gear puller to remove pad driver from motor shaft.

Take care not to misplace motor shaft key.

Install new pad driver, motor shaft key, spacer, washer

and bolt. Then install pad lock keeper, pad and pad

lock. Turn deck assembly over onto pad.

Reattach wires to motor and connect motor wire

harness to frame harness. Tie wires in place. Set

actuator barrel by rotating barrel up or down to set

barrel at 5-3/16 ±1/8 from bottom of frame to bottom of

barrel.

Reattach deck assembly to frame. Install actuator

barrel on to spring retainer bars. Lift bottom of deck

using your hand to align hole for clevis pin. Install clevis

and rue ring.

Turn machine on, raise deck, drive machine check that

machine is working properly. If not recheck actuator

barrel and reset again if needed.

86345050 Chariot Burnisher

5 3/16

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 105 106

Pas de commentaire

Windsor CBE20 Instructions d'exploitation Page 28